![]() ![]() Five years into a new console generation, the PlayStation 3 is all but extinct. The shoulder buttons have a nice, stiff spring return and the (L2) and (R2) shoulder buttons are longer than OEM and curve outward, helping to eliminate the possibility of your fingers slipping off of them. The button response is tight, and the analog sticks feel right. Gamers have few reasons to break out their PS3 (unless they need an oversized paperweight). Performance: The Afterglow AP.2 plays like a champ. Still, if you’ve got a game-worthy PC, those old DualShock 3 controllers can be put to good use. With a few minutes and a Mini USB cable - which you can get for around five bucks on Amazon - you can sync your PS3 Controller with your PC. If that interests you, we’ve thrown together the guide below, so you can ditch the mouse and keyboard for something a bit more traditional. Here’s how to connect a PS3 controller to your PC.Wired Ps3 Afterglow Controller Driver Windows 10 1Īs your Afterglow controller is wired, select the 'Xbox 360 Controller for Windows' option.You will receive a warning about the driver potentially being incompatible, because Microsoft can't verify that it will work for your device. Go with a wired xbox360 or Xbox One compatible controller, they are well supported in windows 10. There are work arounds to use PS3/4 controllers and I've had some success with them but they were a bit of pain to get working right. Here is a simple tutorial to get up to four PS3 controllers working through Xinput on your Windows 8/7/Vista PC. You can see for yourself that the solder joints are well done and that the wires aren't pinched.Make sure you’ve got the official Xbox 360 PC driver.Check your currently installed drivers by opening Command Prompt and typing in “driverquery,” and hitting Enter.Connect your PlayStation 3 controller to your PC via USB, and Windows should begin installing an initial set of drivers.The advantage of this is that any game that Xbox. This also helps to ensure that the quality is high. With the transparent plastic used for the case of the controller, the circuit boards and hardware components are on display for anyone to see. ![]() Well, the Select and Start buttons may be a bit pinkish on the red version, but the circuit boards are a nice red color.Īnyone interested in electronics and videogame controller hardware is likely to find the Afterglow AP.2 especially interesting. Not only are there bright LEDs of either red, green or blue (depending on model), but the circuit boards and the Select and Start buttons are color-coded to match. The unit shown in the product image is the blue version, which, as you can see, has a "cool" look to it when lit. The unit I received for review was red and, well, looked spicy when lit. Part of what gives the Afterglow AP.2 its style is, obviously, its illumination. This is reported to provide up to 15 hours of play, but you probably shouldn't be playing 15 hours at a time, anyway. Powering the untethered AP.2 is a 800 mAh (milliamp hour) non-removable internal Lithium polymer battery. In addition, however, around the front of the controller (where the cord would be on a wired controller), there is a Mini-USB connector, for using the included charging cable to charge the AP.2 and a sync button which pairs the controller up to the included USB dongle. With the exception of the Left Analog Stick and the D-pad being in swapped positions (as compared to the OEM PS3 controllers), everything else is pretty much what you expect, where you expect to see it, including the Select and Start buttons, the Home button, the Action buttons and the shoulder buttons. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |